Lithofin MN Stain Stop 1 Litre Natural Stone Sealer Marble Granite

Lithofin MN Stain Stop is an advanced invisible protective treatment designed for natural stone surfaces. This 1 litre solution deeply penetrates and coats the capillaries with an extremely thin, invisible film, effectively preventing the absorption of oil, grease, and water. Treated surfaces remain protected, allowing spills to be easily removed without leaving stains.

Key Features

• Penetrates into the surface and coats capillaries with an extremely thin, invisible film.
• Oil, grease, and water are not absorbed by the surface, but remain on the surface for easy removal (12 to 36 hours on polished marble and limestone, up to 48 hours on granite and gneiss).
• Facilitates easy removal of oil without leaving stains.
• The effectiveness depends on the amount of product absorbed by the surface.
• The appearance of the natural stone is not affected; some stones may become slightly darker in colour.
• The water absorbency of the stone is greatly reduced (approx. 90-95% reduction).
• The water permeability is only slightly affected (approx. 80 to 90%).
• The product is UV-resistant and does not yellow.

Technical Data

• Density: approx. 0.8 g/cm³
• Flash Point: about 32°C
• Appearance: colourless
• Odor: aromatic

Field of Use

• For invisible protection against staining.
• For facilitating maintenance of all natural stone surfaces, including polished marble.
• Ideal for use on wall and floor surfaces in the kitchen and bathroom, as well as on table tops, window sills, and other sensitive surfaces.

Please Note: Marble and limestone will remain sensitive to acid.

Directions for Use

• Without prior experience or in cases of doubt, try the product in an inconspicuous area prior to use.
• The surface to be treated must be completely dry and clean.
• Areas should be treated in sections of approx. 10 to 15m².
• Evenly apply a consistent amount of Lithofin MN Stain Stop with a brush, a roller, or a cloth.
• On highly absorbent surfaces, this procedure may have to be repeated after five minutes.
• Do not allow the surface residues to dry.
• Residues must be completely removed within 15 min. with a dry cloth.